B – 11 Standard Test Method for Expansion (Pin Test) of Copper and Copper- Alloy Pipe and Tubing, copper, copper alloy, expansion, expansion test, pin. This standard is issued under the fixed designation B ; the 1 This test method is under the jurisdiction of ASTM Committee B05 on Copper. Find the most up-to-date version of ASTM B at Engineering
|Published (Last):||14 March 2011|
|PDF File Size:||15.83 Mb|
|ePub File Size:||9.6 Mb|
|Price:||Free* [*Free Regsitration Required]|
Standard Specification for Ferrovanadium.
Retrieved August 29, B — 02 Standard Speci? Use equipment for the detection and removal of mercury vapor.
List of ASTM International standards
Rockwell hardness shall be made on the inside surface of the tube. When suitable equipment is not available for determining the speci?
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Light-drawn bending temper is used only when a tube of some stiffness but yet capable of being bent is needed.
Norma ASTM B()
The asym shall have the option to specify either a hydrostatic test in Grossman the Grossman method. Preparation for Delivery S4. Workmanship, Finish, and Appearance Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters. Qstm previous edition B — Tubes shall be passed through an eddy-current test unit adjusted to provide information on the suitability of the tube for the intended application.
Dimensions and Permissible Variations Mercurous Nitrate Test Standard Specification for Steel Track Spikes. Alternatively, if the manufacturer uses speed-insensitive eddy-current units that are equipped so that a fraction of aztm maximum unbalance signal is able to be selected, the following percent maximum unbalance signals shall be used.
بانك استانداردهاي گاز
A withdrawn standard has been discontinued by its sponsoring committee. When agreement on the Rockwell hardness tests cannot be reached, the tensile strength requirements of Table 2 shall be the basis for acceptance or rejection.
A superscript epsilon e indicates an editorial change since asstm last revision or reapproval.
A standard may be withdrawn with or without replacement. Originally published as B — 40 T. Rockwell hardness tests shall be made on the inside surface of the tube.
Former soft anneal soft anneal light anneal light anneal soft anneal sstm anneal light anneal light anneal soft anneal soft anneal up to 0. Tubes for Voice and Pneumatic Service S5. Lot Size Pieces Per Lot Sample Size 2 to 8 9 to 90 91 to to to to to to 10 10 to 35 Entire lot 8 12 19 21 27 35 38 46 When, in the case where subsequent testing by the purchaser establishes that the material does not meet these requirements, then the tubes shall be subject to rejection.
For these tubes, the mercurous nitrate test shall be required and nondestructive testing shall not be required. Tube ordered in the drawn H condition is not subject to this test. Grade B7 Studs bolts and Grade B16 Studs bolts fall in this category and are used for high temperature, high-pressure environments like petroleum industry. Limits for unnamed elements are to be established by agreement between manufacturer or supplier and purchaser.
The test method used shall provide for easy visual detection of any leakage, such as by immersion of the tube under water or by the pressure differential method. The tension test for other sizes of tubes need not be made except when indicated by the purchaser at the asm of placing the order.
Screening and resubmittal of samples from rejected lots for visual and dimensional examination is acceptable. A number in parentheses indicates the year of last reapproval.